On Sat, Oct 8, 2016 at 12:30 PM, Stephen Finucane <step...@that.guru> wrote:
> This has been extensively reworked such that the format of the document > matches that of INSTALL.rst. The sum of the content remains the same, > however. > > Signed-off-by: Stephen Finucane <step...@that.guru> > --- > INSTALL.Windows.md | 527 -------------------------------------------- > INSTALL.Windows.rst | 621 ++++++++++++++++++++++++++++++ > ++++++++++++++++++++++ > INSTALL.rst | 2 +- > Makefile.am | 2 +- > 4 files changed, 623 insertions(+), 529 deletions(-) > delete mode 100644 INSTALL.Windows.md > create mode 100644 INSTALL.Windows.rst > > > +Bootstrapping > +------------- > + > +This step is not needed if you have downloaded a released tarball. If > +you pulled the sources directly from an Open vSwitch Git tree or got a > +Git tree snapshot, then run boot.sh in the top source directory to build > +the "configure" script::: > + > + $ ./boot.sh > The old doc used "% command" as the prompt prefix. I see that in the new doc it is "$ command". I'm not a Windows person, but from a quick look, I think "> command" may be the most natural thing to use, so I converted it to that. -- Russell Bryant _______________________________________________ dev mailing list dev@openvswitch.org http://openvswitch.org/mailman/listinfo/dev