Hi Ralf. Well that address would read an int (4 bytes) from Data-block 225 starting with the first byte of the block ...
Chris Am 28.05.19, 10:10 schrieb "Ralf Barkow" <[email protected]>: Thanks Chris, So it's along the lines of HelloOpm.java: PLC_FIELD_ADDRESS = "%DB225.DBW0:INT"; Cheers, Ralf Best regards I Freundliche Grüsse Ralf Barkow Technischer Redakteur | MTD Technische Dokumentation Endress+Hauser Flowtec AG | Christoph Merian-Ring 4 | 4153 Reinach | Switzerland Phone: +41 61 715 6528 [email protected] | www.flowtec.endress.com Disclaimer: The information transmitted is intended only for the person or entity to which it is addressed and may contain confidential, proprietary, and/or privileged material. Any review, retransmission, dissemination or other use of, or taking of any action in reliance upon, this information by persons or entities other than the intended recipient is prohibited. If you receive this in error, please contact the sender and delete the material from any computer. This e-mail does not constitute a contract offer, a contract amendment, or an acceptance of a contract offer unless explicitly and conspicuously designated or stated as such. -----Ursprüngliche Nachricht----- Von: Christofer Dutz <[email protected]> Gesendet: Dienstag, 28. Mai 2019 09:58 An: [email protected] Betreff: Re: HelloPlc4x example, parameter --field-addresses ? Hi Ralf, in general there is no address which is guaranteed to be available in 100% of the cases. But I would assume reading the first 8 bits of the digital outputs should probably work: %Q0:BYTE Or reading a single bit (In this case reading output 4): %Q0.3:BIT Hope this helps. If not, don't hesitate asking ... Chris Am 28.05.19, 09:51 schrieb "Ralf Barkow" <[email protected]>: Dear list, Regarding the HelloPlc4x example, we are able to connect to a S7_1500 but I need some help with the second parameter --field-addresses. Could you give me an example? Thanks, Ralf Best regards I Freundliche Grüsse Ralf Barkow Technischer Redakteur | MTD Technische Dokumentation Endress+Hauser Flowtec AG | Christoph Merian-Ring 4 | 4153 Reinach | Switzerland Phone: +41 61 715 6528 [email protected] | www.flowtec.endress.com Disclaimer: The information transmitted is intended only for the person or entity to which it is addressed and may contain confidential, proprietary, and/or privileged material. Any review, retransmission, dissemination or other use of, or taking of any action in reliance upon, this information by persons or entities other than the intended recipient is prohibited. If you receive this in error, please contact the sender and delete the material from any computer. This e-mail does not constitute a contract offer, a contract amendment, or an acceptance of a contract offer unless explicitly and conspicuously designated or stated as such.
