Here is the code snippet for scanning LUNS (drivers/scsi/scsi_scan.c in
function
__scsi_scan_target()):
/*
* Scan LUN 0, if there is some response, scan further. Ideally, we
* would not configure LUN 0 until all LUNs are scanned.
*/
res = scsi_probe_and_add_lun(starget, 0, &bflags, NULL, rescan, NULL);
if (res == SCSI_SCAN_LUN_PRESENT || res == SCSI_SCAN_TARGET_PRESENT) {
if (scsi_report_lun_scan(starget, bflags, rescan) != 0)
So, if we don't get a response while scanning LUN0, we will not use
scsi_report_lun_scan().
On Hyper-V, the scsi emulation on the host does not treat LUN0 as anything
special and we
could have situations where the only device under a scsi controller is at a
location other than 0
or 1. In this case the standard LUN scanning code in Linux fails to detect this
device. Is this
behaviour expected? Why is LUN0 treated differently here. Looking at the scsi
spec, I am not sure
if this is what is specified. Any help/guidance will be greatly appreciated.
Regards,
K. Y
_______________________________________________
devel mailing list
[email protected]
http://driverdev.linuxdriverproject.org/mailman/listinfo/devel
