Use comedi_request_region() to request the I/O region used by this driver. Remove the default iobase address (0x240) that is used when the user does not pass a base address during the "comedi_config". Comedi legacy drivers should only attach to a specified address.
Remove the noise when the board is first attached as well as the error message when the request_region() fails, comedi_request_reqion() will output the error message if necessary. Signed-off-by: H Hartley Sweeten <[email protected]> Cc: Ian Abbott <[email protected]> Cc: Greg Kroah-Hartman <[email protected]> --- drivers/staging/comedi/drivers/dt282x.c | 14 +++----------- 1 file changed, 3 insertions(+), 11 deletions(-) diff --git a/drivers/staging/comedi/drivers/dt282x.c b/drivers/staging/comedi/drivers/dt282x.c index 19f0b99..0661045 100644 --- a/drivers/staging/comedi/drivers/dt282x.c +++ b/drivers/staging/comedi/drivers/dt282x.c @@ -1123,18 +1123,10 @@ static int dt282x_attach(struct comedi_device *dev, struct comedi_devconfig *it) int i, irq; int ret; struct comedi_subdevice *s; - unsigned long iobase; - iobase = it->options[opt_iobase]; - if (!iobase) - iobase = 0x240; - - printk(KERN_INFO "comedi%d: dt282x: 0x%04lx", dev->minor, iobase); - if (!request_region(iobase, DT2821_SIZE, dev->board_name)) { - printk(KERN_INFO " I/O port conflict\n"); - return -EBUSY; - } - dev->iobase = iobase; + ret = comedi_request_region(dev, it->options[0], DT2821_SIZE); + if (ret) + return ret; outw(DT2821_BDINIT, dev->iobase + DT2821_SUPCSR); i = inw(dev->iobase + DT2821_ADCSR); -- 1.8.1.4 _______________________________________________ devel mailing list [email protected] http://driverdev.linuxdriverproject.org/mailman/listinfo/devel
