On Wed, Sep 01, 2010 at 12:16:01PM -0700, Cherry Withers wrote: > When I updated to the new Sugar [OLPC OS] release of 852, the Firmware > stayed in its old version of Q3A36.
Was external power connected at the time of a reboot? Only then will firmware be updated. If not, it's a bug, and I'll need to work with you to determine the cause. Let me know if the external power was connected before a reboot? > So the statement above is incorrect? No, I don't think so. > Or is this just a matter of doing a clean build (using the first part > of the instructions on the wiki) versus an "update"? It should also happen after an olpc-update, is that what you did? It's not clear from your mail. How did you reach os852; using fs-update, using four game key press, or using olpc-update? > Is Q3A50 the accompanying "release" version of the firmware? No, Q3A48 is the firmware version embedded in os852. You need Q3A50 on a NANDblaster sender though. > In http://wiki.laptop.org/go/Nandblaster_for_XO-1.5 > > - I'm assuming that "finding the channel" for either the sender > happens automatically (ie, there's no need for additional set-up by > going through the neighborhood and connecting to a wifi network, > etc.). It's just a matter of both the receiver and sender to be on the > same channel ... The sender picks the channel with the least activity. The receiver checks all channels for a sender. > and to ensure success > just force the channel Yes, forcing the channel may increase the chances of success, but doing it without knowledge of the radio conditions may decrease the chances of success. > (in my head I've associated the channels to the mesh > channels which are no longer in XO 1.5)? This may change. > - there are no instructions for setting up the Receiver. Is it safe to > assume that we should follow the instructions for NANDblasting the XO > 1.0 when it comes to the Receiver? There are instructions for setting up the receiver ... start them with the four game keys held down, says the page. Then it says ... if this does not work, you may need to manually update the firmware first. This should not be required for laptops shipped recently. If you've been using prototype laptops then you may need to upgrade the firmware version first. What firmware version are they? You mentioned Q3A36 above. This is far too old. The Wiki page says you should use Q3A45 or later if the laptops do not start receiving. The instructions do not describe how to upgrade the firmware first, because in most cases that will not be required, and besides the time cost of checking the firmware version is higher than the time cost of just trying to receive the broadcast. The procedure is optimised for mass deployment, not mass upgrade. -- James Cameron http://quozl.linux.org.au/ _______________________________________________ Devel mailing list Devel@lists.laptop.org http://lists.laptop.org/listinfo/devel