On Thu, Sep 5, 2013 at 9:16 PM, James Cameron <qu...@laptop.org> wrote:
> This is normal. > > You have been given units with incomplete manufacturing data. > > How did that happen? > > Please pick two units, a working unit and a failed unit, and get to > the ok prompt. > > Type .mfg-data and compare the output. > > You should find you will need to: > > - delete the TS tag (ok delete-tag TS), > > - add the TS tag with a value of SHIP (ok add-tag TS SHIP), > > - delete the BD tag (ok delete-tag BD), > > Then try booting. > Thanks, that kind of worked, except the screen backlight keeps on dimming and brightening randomly. It does boot and connect to an AP though :-) I'll check some more units .... So I went back to 12.1 and same thing. Screen > > On Thu, Sep 05, 2013 at 09:07:33PM -0400, Kevin Gordon wrote: > > Hi: > > > > The deployment preparation g-ds are not being kind to me today. I have > > prepared about 35 XO 1.75s to go out. However, I have another 15 that > are > > causing me new grief. > > > > The messages on boot are: > > > > USB devices: > > /usb@d420800/hub@0,0 > > OLPC 1C2, 800MHz, 1GiB memory, 4 GB internal storage, S/N SHC23500C88 > > Open Firmware Q4D34 EC Firmware 1.0.01 2013-09-06 00:54:24 UTC > > WARNING TS tag is not SHIP > > > > Type the Esc key to interrupt automatic startup > > Boot device: /wlan Arguments: > > Scan for OLPCFW not found > > <buffer@fda3f514:0; > > Can't open boot device > > > > i have used the same 5 USB .sticks for the 35 that worked, and the 15 > that > > havent. > > > > I flashed the firmware from the USB and that worked and rebooted as above > > I did a 4key build install using 32013o2.zd and the fs2.zip and that went > > through the reflash process seemed to go through fine, but the reboot > comes > > back with the above message. > > The icon comes up, the sound plays, then the above messages come up. > > > > After the reflash, there are two other messages under the first > /usb@d420800/ > > hub@0 with the same start then a /scsi@4,0 and another with a /scsi@4 > ,0/disk > > > > i tried a test-all, and it seemed to go very well up to a point wherein > there > > were a ton of IO_RW_DIRECT response=CMD state; invalid function; > > sdio-poll-di-ready failed. > > > > Any ideas? > > > > If it were a 1.5, I'd try to swap the SDHC card, but these are 1.75's > :-) > > > > Thanks > > > > KG > > > > > > > _______________________________________________ > > Devel mailing list > > Devel@lists.laptop.org > > http://lists.laptop.org/listinfo/devel > > > -- > James Cameron > http://quozl.linux.org.au/ >
_______________________________________________ Devel mailing list Devel@lists.laptop.org http://lists.laptop.org/listinfo/devel
