Thanks Alex, So in this JTAG example does the run command begin the 3 step boot process you outlined?
Also how should I be generating sel4bench-image-arm-zynq7000? Right now I am working from the sel4test repository https://github.com/seL4/sel4test configured to target Zynq-7000. When I try the "dow images/sel4bench-image-arm-zynq7000" on images generated using the standard make command and also with make build-binary and make build-uBoot, I get an error: Code 16 Time 1485875053070 Format {Invalid context}. Looking at the configuration this seems to be designed for the Xilinx ZC706, ARMv7a, Cortex A9. However the zed board has a ZC702. Would this be the source of my problem or should sel4 work with the ZC702 as well? Thanks again, Jeff -----Original Message----- From: [email protected] [mailto:[email protected]] Sent: Monday, January 30, 2017 5:40 PM To: Brandon, Jeffrey - 0553 - MITLL Cc: [email protected] Subject: Re: [seL4] seL4 on Zedboard Hi Jeff, The boot process is as follows: 1) u-boot loads the seL4 ELF file into memory at ${loadaddr} 2) u-boot reads the ELF file and copies the appropriate sections to the correct address for program execution 3) u-boot reads the entry point from the ELF file and jumps to the address to start execution. So ${loadaddr} can be anything that you like, as long as it does not overwrite any part of u-boot or occupy the space at which the ELF sections will be copied. Loading from SD can be quite awkward during development. I recommend using JTAG via the XMD tool. Here is an example of the required XMD commands: ------------ connect arm hw rst fpga -f hardware/bitstream.bit source hardware/ps7_init.tcl ps7_init ps7_post_config dow images/sel4bench-image-arm-zynq7000 run exit ------------- - Alex On Mon, 2017-01-30 at 16:04 +0000, Brandon, Jeffrey - 0553 - MITLL wrote: > Hi, > > > > I’ve been trying to get seL4 running on a Zedboard and I was wondering > if there was any documentation on how to boot sle4 from an SD card. > > > > I’ve read > > http://sel4.systems/pipermail/devel/2016-December/001160.html > > and > > https://sel4.systems/Info/Hardware/General/ > > which mentions using ${loadaddr} but that doesn’t seem to be defined > on the Zedboard’s u-boot. > > > > So far I’ve compiled the image targeting the zynq7000 and used the > mkimage command from the general hardware page to try u-boot’s > fastboot, but fastboot doesn’t seem to be available on the zynq > either. > > > > I am a bit of a novice here. I worry that the solution may be simple > but I am currently taking shots in the dark. I wanted to ask this list > for any resources you may be aware of for getting sel4 test cases > running on the Zed. > > > > Thanks for the help, > > > > Jeff Brandon > > 05-53 Secure Resilient Systems and Technology > > > > > _______________________________________________ > Devel mailing list > [email protected] > https://sel4.systems/lists/listinfo/devel
smime.p7s
Description: S/MIME cryptographic signature
_______________________________________________ Devel mailing list [email protected] https://sel4.systems/lists/listinfo/devel
