I didn't see an email list that seemed appropriate so....
Does anyone know how I can access the SPI signals on my Neo? The wiki's v3 debug board page implies that these signals are brought out through the debug header and will be made accessible on the v3 board, however the advanced kit apparently is shipping with the v2 debug board. (I don't know how to verify this; my debug board has no version indication that I recognize.) If SPI is actually brought through the debug header, all I really need is a pin-out list for that header (and a really small soldering iron!). As I'll need a few more signals beyond SPI, having such a list would be great - but I don't see that documented on the wiki. Does anyone know if that header is documented? Thanks... NOTE: The information in this message is intended for the personal and confidential use of the designated recipient(s) named above. To the extent the recipient(s) is/are bound by a non-disclosure agreement, or other agreement that contains an obligation of confidentiality, with AuthenTec, then this message and/or any attachments shall be considered confidential information and subject to the confidentiality terms of that agreement. If the reader of this message is not the intended recipient named above, you are notified that you have received this document in error, and any review, dissemination, distribution or copying of this message is strictly prohibited. If you have received this document in error, please delete the original message and notify the sender immediately. Thank you. AuthenTec, Inc. http://www.authentec.com
