Tony Lindgren wrote at Friday, January 27, 2012 10:38 AM: ... > So how about let's do separate static and dynamic bindings, > something like this: > > /* > * Static init time only mux where > * we only specify phandle to driver > * and, offset of the mux, and the value. > * These pins are discarded after init. > * > * Format: mux_ctrl offset value > */ > pinctrl-static = <&pmx_driver1 0x0020 0x1245 > &pmx_driver2 0x0022 0x6578>;
So those are direct register writes? That sounds pretty scary, and a royal pain to author the device tree. If we do go with this, I think we'd need a mask for each register write too, so you can leave certain bits unaffected; there's no reason to believe in general that each pin has a dedicated register only for that pin, or even that only pinmux/config data is in the register. This also makes it difficult to extract semantic information from the DT. How can the pinctrl subsystem know which pins are in use and which aren't here? This is relevant if some module loads later and attempts to claim some pins - are they already in use by another driver or not? Now individual pinctrl drivers could interpret those register values and know that this means pin/group "x" is programmed to mux value "y", but does that mean pin "x" is actually /used/, or just that the init table had to program value "y" because the default for that pin is "z" which conflicted in HW with some other mux setting that the board needed (e.g. muxing signal "y" to some other pin). (Put another way, this binding completely bypasses the pinctrl subsystem; is that OK?) > /* > * Dynamic mux where the mux is kept around after > * init and multiple states can be defined for > * a mux as a subnode of the pinmux controller. > * > * Format: mux_phandle initial state > */ > pinctrl-dynamic = <&pmx_sdhci PMX_STATE_ENABLED > &pmx_ehci_xcv PMX_STATE_ENABLED>; > > This would make pinctrl-static binding follow the same > standard as GPIO binding and can be parsed easily with > of_parse_phandle_with_args. > > Then for pinctrl-dynamic we can make a custom parser, > and the binding can follow the more readable format as > Simon posted. I don't think there's any point in having 2 separate bindings; it's been hard enough to come up with /one/ binding! If we do go for raw register writes for the static stuff, we should just do the same for the dynamic stuff too. In fact, given this would all bypass the pinctrl subsystem entirely, perhaps lets not even define a standard format for pinctrl-static or pinctrl-dynamic, and just have each pin controller driver parse tables inside its own node, in a format specific to that pin controller's binding. I already had that working for the static case back in last August and would love to just apply those patches and be done with this. -- nvpublic _______________________________________________ devicetree-discuss mailing list devicetree-discuss@lists.ozlabs.org https://lists.ozlabs.org/listinfo/devicetree-discuss