I do not know about the SignaLink really, but if you have it connected
correctly to the rear accessory port, there is nothing you need to do
with the radio. When the PTT line is grounded, it enters TX mode.
Thus, I would look into either your software setup (look for a PTT com
port and/or DTR/RTS high/low type setup) or possibly the SignaLink cable
setup (if it's anything like the RigBlaster that has jumpers you have to
setup correctly.
Also, you may want to check out the TS-2000 group:
http://groups.yahoo.com/group/KenwoodTS-2000/ ... I belong there and
they may be able to help as well... but I really think it's software or
the SignaLink setup.
Jeremy
KB8LFA
http://www.kb8lfa.com
On 7/2/2010 3:19 PM, greathounder wrote:
This morning UPS brought my SignaLink USB. I've got it connected thru
the 13 pin ACC port in back. I'm using Air Link EXpress. I can get it
to decode the signal, but when I click on tune, my ptt light doesn't
turn on. It must be something I haven't done on the radio. Any Ideas?
Thanks in advance 73 Bill N8VWI