Hi-
I'm developing a 4-channel receiver using 4 rx paths and 2 LFRX
daughter boards. I'm basing my code on the multi_* examples in the
multi-antenna directory. Two of the channels I want to capture are
AM-modulated at roughly 2 MHz carrier frequency, the other two signals are
not modulated and are low frequency on the order of 1 kHz.
My question is, can I tune each subdevice to a different frequency? I
would need to in order to capture both sets of signals simultaneously in a
phase-locked fashion (this is important).
thanks,
eric
************************************
Eric H. Matlis, Ph.D.
Aerospace & Mechanical Engineering Dept.
120 Hessert Center for Aerospace Research
University of Notre Dame
Notre Dame, IN 46556-5684
Phone: (574) 631-6054
Fax: (574) 631-8355
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
