======================================= RFX400 to be discontinued =======================================
The RFX400 daughterboard will be discontinued when the current stock runs out. We have designed a replacement for it which will significantly exceed the capabilities of the RFX400 in many ways. However, our stock of RFX400s is expected to run out before the new daughterboards will be available. Therefore, if any of the following apply to you: 1 - You will need more RFX400s to match others you currently have and can not use a board with different characteristics 2 - You will need RFX400-type capabilities within the next 3 months and cannot wait until late December or possibly early January Then we suggest you make a "lifetime buy" purchase at this time. If your organization's purchasing procedures will cause that to take some time, please send an email to [EMAIL PROTECTED] letting us know how many you will need. The RFX400 has already been removed from the normal credit card ordering page. To purchase it by credit card, please use the following alternate page: http://www.ettus.com/special_order.html ====================================== RFX900 and RFX1800 to be discontinued ====================================== We also have plans to replace the RFX900 by mid December, and the RFX1800 by mid-March, so the same issues as the RFX400 has above also apply to these boards. However, we have a somewhat larger stock of these boards on hand which we believe should last until their replacements are available. We have not removed these boards from the main ordering page yet. ====================================== Possible long lead time on RFX2400 ====================================== Due to an unexpected large purchase of RFX2400s, our stock has run low. We expect more to be available in about 6-7 weeks. In the mean time, there are still a few left. We do have a large quantity of RFX2400s which, by customer request, (which was subsequently canceled...) were customized to bypass the 2.4 GHz ISM band filter (2 traces were cut). You might be able to "unbypass" the filters by soldering across the cut traces, but we cannot guarantee that. You also might not need the ISM filter in your application. Power output does typically increase about 1-2dB. If this configuration is acceptable to you, then you can order one of those by placing an order for a normal RFX2400 and then sending an email to that effect to [EMAIL PROTECTED] ======================================= We apologize for any inconvenience the above may cause. If you wish to be removed from this mailing list, please follow the directions below. Matt Ettus Ettus Research LLC [EMAIL PROTECTED] _______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org http://lists.gnu.org/mailman/listinfo/discuss-gnuradio