Thanks Josh,
Its the end of the work day here.. so i am going to take off. I will
try it first thing. The GRC I am using is from the trunk so ill just
recheck it tommorrow. I am using the basic Tx and basic Rx.
Isaac
Josh Blum wrote:
I just checked in an two tone loopback example to the grc trunk. The
setup that I just tested it on is a usrp with basic rx and basic tx,
with txa and rxa connected together.
Could you post what daughter boards that you are using. You will have to
use the grc trunk to use the above example.
-Josh
isaacgerg wrote:
No luck. Can you send me an example xml schema for a transmitter that
you
know works?
Thanks in advanced,
Isaac
Josh Blum wrote:
isaacgerg wrote:
Does anyone have an .xml file that shows an example of doing this?
Currently, I have a USRP sink with the following parameters and I
cant get
any signals on my Rx USRP. I know my Rx USRP is working as I can
run the
gnuradio ptt example and I can see energy appearing on the PSD.
Here are my USRP Sink parameters:
Input type: complex
usint #: 0
subdev spec: side B
freq: 25000000
gain 3200
mux 0x0
auto t/r : ignore
tx enable: enable
interp: 400
The input to the sink is a cosine wave at 10000 with amplitude 100.
Thanks in advance.
Im not sure about the board you are using, but the actual allowed
gain parameter is way less than 3200. Set the usrp gain to 0, and try
a amplitude of 5000 for the signal source.
-Josh
--
[EMAIL PROTECTED] - Sr Systems Engineer
Voice: 814-278-3019
_______________________________________________
Discuss-gnuradio mailing list
[email protected]
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
