I did all the modifications on rfx900.
when trying to burn eeprom i receive the following error.

bash: burn-db-eeprom: command not found

I am trying to run the command in the following manner (after mounting the 
rfx900 on side A of USRP rev 3):

go...@ubuntu:~/gnuradio/usrp/host/apps$burn-db-eeprom -t rfx900_mimo_a -f -A -B

What am i missing?
Is there any problem with the permissions? If yes, then how to set permissions 
correctly?

Gohar
  



The newer way will have better phase noise.

Matt


Newell Jensen wrote:
> When doing this modification, is there any performance differences 
> between using a setup with this modification versus a newer USRP1 that 
> doesn't need this modification?  I think I had heard that the newer 
> USRP1 has better clock performance or something for the RFX900 boards 
> and didn't know how much a setup with this modification would perform 
> in comparison to a setup with a newer USRP1 (using the RFX900 boards).
>
> On Thu, Jan 15, 2009 at 11:23 PM, Matt Ettus 
> > wrote:
>
>     Gohar wrote:
>
>         Hi,
>         Is it possible to use rfx900 with usrp rev 3 hardware that was
>         released in 2005? If yes, what changigs should be made on
>         either board (usrp board or rfx900 board) ?
>
>          
>
>
>     On the RFX board
>       Move R36 to R34
>       Move R115 to R116
>
>     Put the rfx board on the USRP and run
>
>       burn-db-eeprom -t rfx900_mimo_a -f -A -B
>
>     Matt
>



       
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio

Reply via email to