Hi all, Did any body else had a problem while transmitting through USRP board?
I am using Basic Tx/Rx board. When I tried to send a sinusoidal signal of 50Khz
(through GRC) and tried to look at at the transmitted signal on to the
oscilloscope by probing the Tx SMA connector, it displayed a sinusoid of 25Mhz
with a constant DC offset. I guess there is an up conversion to an IF frequency
is been done in USRP, but do anybody know is there any fixed frequency the
signal is up converted to? At what mamimum power can a signal be transmitted
using USRP?Is there a way we can control Transmission Power?
Also when I unplugged the power to USRP and the USB cable, then also I was able
to see a sinusoid, on the scope, of 60Mhz.
Is there anything we need to enable in order to make the transmitter work? Also
is there any kind of reference manual available for the Basic TX/Rx Daughter
board?
Thanks & Regards,
Somya Ajmera
New Email names for you!
Get the Email name you've always wanted on the new @ymail and @rocketmail.
Hurry before someone else does!
http://mail.promotions.yahoo.com/newdomains/aa/_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
