yes, of course
http://www.ettus.com/usrp2_vrt
Eric Blossom wrote:
On Mon, Dec 28, 2009 at 05:21:36PM -0500, Josh Blum wrote:
Tim Pearce wrote:
Josh,
The USRP2 doesn't respond when loaded with the firmware at:
http://www.ettus.com/usrp2_vrt
I've just run find_usrps -e eth1 with wireshark running and can only see the
outgoing packet:
1 0.000000 Toshiba_b4:52:54 Broadcast 0xbeef Ethernet II
Given the transport type is the old (I think) 0xbeef I guess this is wrong,
I'm just about to recheckout the source code and compile again, but "vrt" is
a directory present in where I compiled gnuradio from - I've just double
checked by:
The vrt directory was there prior to this work. A good way to verify
that you pulled in the right branch would be to check
usrp2/firmware/include/usrp2_eth_packet.h and see that it has the
following defines:
#define U2_DATA_ETHERTYPE 0xBEEF // used in our data frames
#define U2_CTRL_ETHERTYPE 0xBEF0 // used in our control frames
Thats where the firmware and host code gets the ethernet transport
type from.
-Josh
Josh,
Did you post a copy of the FPGA image? They'll need that for any of
this stuff to work ;-)
Eric
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
