Thank you Jason, I could able to see the exact waveform of the samples
from One USRP2 to another USRP2. But i found the scaling of the
amplitude when I see from usrp2_fft.py and attaching a Scope Sink (like
oscilloscope scope sink), there is much variance, which usrp2_fft.py is
showing much amplified scale, but the real one of Scope Sink in the GRC
is showing very very low amplitude factor, Is there any understanding is
required here? And if i want to get some amplified result what to be done?
best regards,
srinivas.
Jason Uher wrote:
On Wed, Jan 27, 2010 at 3:31 AM, srinivas naga vutukuri
<srinivas.vutuk...@gmail.com> wrote:
Am sending a +1 to -1 amplitude square wave samples from Tx and when i
capture on Rx end its not almost a square wave. I have generated the above
I believe this is the maximum output power for the USRP2, and your are
likely seeing distortions from the non-linearity of the circuits
involved. I'm not sure what the linear range is for your
daughterboards, but try turning it down to +/- 0.3 and see what
happens.
Also, make sure that your decimation/interpolation factors are
correct. That is, if the DAC and ADC are operating at different
sample rates, you have to adjust your int/dec factors or samples per
symbol accordingly.
Jason
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
