Hi Bryan, On Jul 16, 2010, at 1:27 AM, Bryan Edelman wrote:
> Hardcode audio_rate to 48000, set audio_decimate = 6, usrp_decim = 312, > chanfilt_decim = 1. Hard-coding these values worked! There was still a lot of static, but the music sounded fine and was playing back at the correct frequency/sample rate. There were no audio under-runs. > Ensure that the fm station is physically nearby so you have a nice strong > signal. I get SSSSSSSS (seq num error) in the terminal but it sounds fine. The FM station is a public FM station, so perhaps signal strength is an issue. I'm using a 75cm long wire antenna connected to the RX port on the WBX module. Is there some way to improve signal reception, to that of let's say car audio FM systems, using the USRP2 + WBX combination? There's a signal attenuator and low-noise amp for the WBX RF front-end module, shouldn't that be sufficient to get clear broadcast FM radio? Elvis Dowson _______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
