Hi All,
I'm about to connect another receiver to the DBSRX to see the spectrum.
Q1: can I break sumthing if connect it straight (receiver -> DBSRX)
Q2: should I use an attenuator (ex: TV 0....20 dB)
Patrik
What kind of receiver is it, how much gain, and what is its maximum
output level?
The DBSRX has a GaAs LNA on the front-end, which doesn't really like
signals above -10dBm, I would put in at least 30dB, depending on
what the signal source is. The DBSRX (and DBSRX2) are both capable
of "seeing" signals down to below -120dBm all by themselves, so
if you're using them as "IF processors" for high-frequency receivers,
put in a fair amount of attenuation. Even without the hazard of
damaging the LNA, you don't want to end up in non-linear territory
because of too-high levels going into the receiver card.
With the exception of the BASIC_RX and LF_RX, all of the Ettus receivers
are generally designed for "off air" reception, connected
to an antenna. So if you're using them as the "IF", you should
definitely attenuate the input levels down quite a bit.
--
Marcus Leech
Principal Investigator
Shirleys Bay Radio Astronomy Consortium
http://www.sbrac.org
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio