Not an expert here but, just a couple of questions/suggestions. HackRF One only properly works with either 8, 10, 12.5, 16 or 20 MHz sample rate, other sample rates selected and I think it won't work, but instead use default value (8M), or the closer one. So most likely your hardware in both script is actually running at 8 Msps
Why you have difference in sampling rate between your blocks? You are feeding your TX with 32k while it should need 8M at input, you could need a resample block there. Also in your RX your bandpass filter input should be running at 8M as that's your hardware rate and then use decimation to decrease to 32k if 8M / 32k is an integer value or another resampler method if not. This is also valid for other blocks, unless the block van do it itself you need to keep same rate through your script or do resampling when needed. Best regards Raydel. CM2ESP Hi Jimmy, Thank you very much for your response. As i mentioned it in another answer, i used this block because it was so advised in this topic:https://github.com/gnuradio/gnuradio/issues/1314 And this had a good effect on the quality of the transmitted sound. Thanks in advance, Timur On 15.12.2017 22:46, Jimmy Chau wrote: Hi Timur, I’m not sure if this is your main problem, but we generally don’t recommend using a Throttle block with hardware sources or sinks. Instead, the hardware alone should control the sample rate. It is plausible that your Throttle block is preventing the "osmocom Sink" from getting samples quickly enough. -Jimmy On Dec 15, 2017, at 4:17 PM, Timur Karychev <tkary...@hs-mittweida.de> wrote: Hi Marcus, Please find attached Screenshots of (tx/rx) flowgraphs that I used to transfer the file. Without Codecs. The sound lasts well for several tens of seconds, then errors are heard. I'm transmitting the wav file with 8 KHz Samplerate. I hope you can help in this matter. Looking forward to receiving your reply. Thank you. Timur On 15.12.2017 17:17, Müller, Marcus (CEL) wrote: Hi Timur, there's infinitely many things that can go wrong – this might be a design mistake, this might be device imperfections, or this might really just be noise on your wireless channel. So, without you posting all details about your transmitter/receiver implementation, this will be pretty impossible to answer! Looking forward to more info, Regards, Marcus <tx_BPSK.grc.png><rx_BPSK.png>______________________________ _________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org https://lists.gnu.org/mailman/listinfo/discuss-gnuradio _______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
_______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
