On 2022-03-16 18:17, Chad Spooner wrote:
Marcus:
That did it! Thanks much.
I was definitely confused about being able to use both TX/RX and RX2
on subdev B to receive two signals. When I was doing that, I was
thinking 'B:0' was sufficient--same device. But switching the antenna
back to A, RX2 (as in the original two-block configuration) and using
'A:0 B:0' worked, so then I switched back and tried 'B:0 B:0' but that
doesn't work.
Now I also understand (a little bit better anyway) the documentation
https://files.ettus.com/manual/page_configuration.html
I appreciate your patience and skill Marcus,
C
A side note. NEVER wire a transmitter directly to a receiver. Use a
30-40dB attenuator in-line. Because receivers that are intended for
off-air (antenna-connected) signals are
too delicate to tolerate the kind of power levels you'll see directly
from a transmitter, even a very very modest transmitter. You risk
damaging the receiver.
