Hello,
I have gnuradio 3.10 and I wanted to install gr-air-modes. In the chat
one of the moderators told me the version of gr-air-modes that is
compatible with gr3.9 would work with gr3.10.
So I installed this version in my computer, the installation was
successfull however when I execute rx_modes I do not receive any signal.
The output of the command is :
Inspiron-3793:~$ modes_rx
gr-air-modes warning: numpy+scipy not installed, FlightGear interface
not supported
[INFO] [UHD] linux; GNU C++ version 9.2.1 20200304; Boost_107100;
UHD_3.15.0.0-2build5
[INFO] [B200] Loading firmware image:
/usr/share/uhd/images/usrp_b200_fw.hex...
[INFO] [B200] Detected Device: B200
[INFO] [B200] Loading FPGA image:
/usr/share/uhd/images/usrp_b200_fpga.bin...
[INFO] [B200] Operating over USB 2.
[INFO] [B200] Detecting internal GPSDO....
[INFO] [GPS] No GPSDO found
[INFO] [B200] Initialize CODEC control...
[INFO] [B200] Initialize Radio control...
[INFO] [B200] Performing register loopback test...
[INFO] [B200] Register loopback test passed
[INFO] [B200] Setting master clock rate selection to 'automatic'.
[INFO] [B200] Asking for clock rate 16.000000 MHz...
[INFO] [B200] Actually got clock rate 16.000000 MHz.
[INFO] [B200] Asking for clock rate 32.000000 MHz...
[INFO] [B200] Actually got clock rate 32.000000 MHz.
Setting gain to 38
Gain is 38
Rate is 4000000
please can i get some support to solve this problem?