A common problem for many people using net-UDAP is that the PC (or
laptop) you are using to configure the Receiver has to be in the same
subnet as the Receiver itself. If the PC/laptop is already connected to
a network and the internet then it will not work.

There is some kind of procedure that goes on when you reset the Receiver
that uses an unusual IP for the Receiver and PC.  Not sure how it works,
but I always do the following:

1. Disconnect the PC from any network, wired or wireless
2. On the PC, in the properties of the network adapter, remove any fixed
IP address from the TCP/IP (V4) making sure it is obtaining its IP by
DHCP (automatic)
3. Reboot the laptop or PC just to make sure the changes have stuck
4. With the Receiver switched off connect one end of a short Ethernet
cable to the Receiver and the other to the network socket of the PC
5. Power on the Receiver and press and hold the front button until it
flashes rapidly red
6. Wait until it turns to a slow flashing red light then launch the
net-UDAP application.
7. Run the "discover" routine

Provided the Discover routine works you can proceed with making your
commands.

Because it won't be possible to consult any web site while you are doing
this (unless you are running a second PC for the purpose) it is a good
idea to print all instructions out beforehand and have a good idea of
the commands you will be uploading before you go through this
procedure.

Good luck!


------------------------------------------------------------------------
TheLastMan's Profile: http://forums.slimdevices.com/member.php?userid=16021
View this thread: http://forums.slimdevices.com/showthread.php?t=95154

_______________________________________________
discuss mailing list
discuss@lists.slimdevices.com
http://lists.slimdevices.com/mailman/listinfo/discuss

Reply via email to