RobbH wrote: > I do not know if I can help you, as I have no experience with your > issues, so anything I say is mainly speculation. I have very little > expertise; I'm just a user of LMS who likes to tiniker. There is a very > good chance that everything I say will turn out to be wrong! > > Philosophically, I think starting anew makes sense, but you do not have > to ditch entirely the current setup in order to do so. Just set the > current SD card aside and start over with a fresh SD card. You can > always go back to the current one if the second attempt does not work > out. You are a lot more familiar with pCP now than when you first set it > up, so it is possible that you misunderstood or overlooked something > then. Is it likely? I don't know, but it should be easy to try. > > I have one suggestion for you. As I said, it is not based on any > personal experience, so it may not be helpful. > > In the pCP (not LMS) web interface, go to the Squeezelite Settings tab. > About halfway down the page there is a field for "Close output setting." > Put some value in that field and click the "Save" button below. This > will tell Squeezelite to release the output device after a number of > seconds (the value you put in the field) of silence. This is intended to > allow Squeezelite to share the output device with other players, instead > of keeping it locked when not in use. It is not intended to help with > your situation, and it may not. But since it does require Squeezelite to > reconnect with the output device when it is used again, I think it might > be worth a try. > > I hope I am not wasting your time with this suggestion, although that > may well be the case. Good luck! > > Incidentally, you may already be aware of this, but just in case it > might be helpful to know that Squeezelite is not a commercial product. > No one is paid to maintain it. When work is done on it, it is done in > spare time, as available. You may not see signs of progress, especially > if it is not clear that the problem is within Squeezelite. Thanks for investing the time to answer my question. Any potential hint is much appreciated, regardless of whether it solves my issues or not. I do know that pCP is not a commercial solution. I know it is very much a donation based project (I donated a few bucks recently) :) I will take a look at the "Close output setting"! :)
------------------------------------------------------------------------ kitus's Profile: http://forums.slimdevices.com/member.php?userid=73121 View this thread: http://forums.slimdevices.com/showthread.php?t=117179 _______________________________________________ discuss mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/discuss
