eth1, sorry for typo mistake. 在 2012-5-18 上午11:48，"Robin Wang" <[email protected]>写道：
> Because uplink doesn't need IP address. Here eth0 is used to connect two > switches, one virtual, one physical. Thanks. > 在 2012-5-18 上午10:49，"Salman Malik" <[email protected]>写道： > >> Hi Dongsheng, >> >> Could you please tell me, why do we need to clear up the eth1 IP address? >> Does it interfere with the bridge ? If yes then how ? >> Bridge management is a bit unclear to me so thats why I am asking. >> >> Thanks, >> Salman >> >> >> > From: [email protected] >> > Date: Fri, 18 May 2012 10:32:23 +0800 >> > To: [email protected] >> > CC: [email protected] >> > Subject: Re: [ovs-discuss] why vm can't ping host eth1 >> > >> > On Thu, May 17, 2012 at 7:12 PM, yue wang <[email protected]> wrote: >> > > >> > > i think vm1/vm2/host are connected to each other by OVS, vm and host >> should communicate with each other. >> > >> > Sure, please see another thread: >> > http://openvswitch.org/pipermail/discuss/2012-May/007201.html >> > >> > You must clean ALL ip address on eth1, and set the ip address on the >> > corresponding bridge device, >> > say 'br1', here is a example: >> > >> > /usr/bin/ovs-vsctl add-br br1 >> > /usr/bin/ovs-vsctl add-port br1 eth1 >> > >> > /sbin/ip addr add ${IP} dev br1 >> > /sbin/ip link set br1 up >> > /sbin/ip address flush dev eth1 >> > /sbin/ip route replace default via ${GW} # if you have gateway >> > corresponding eth1 >> > _______________________________________________ >> > discuss mailing list >> > [email protected] >> > http://openvswitch.org/mailman/listinfo/discuss >> >> _______________________________________________ >> discuss mailing list >> [email protected] >> http://openvswitch.org/mailman/listinfo/discuss >> >>
_______________________________________________ discuss mailing list [email protected] http://openvswitch.org/mailman/listinfo/discuss
