On Monday, February 24, 2014 11:17:09 a l wrote:
> On that note, in the basement there is (was)a breaker panel that had its
> cover off. no one was working on it and I was unsure of any wires status do
> I did not fiddle with it. My understanding is that energized panels -must-
> be covered in order to comply with code.
> 
> Lastly, there need to be plans for a licensed electrician to check this
> work. I've voiced my distaste about amateur electrician work being done at
> the space but this seems to be falling on deaf ears. This is a serious
> liability issue.

ok.

what are your plans then?

> 
> Regards,
> Andrew L
> 
> On Feb 24, 2014 8:25 AM, "Michael Griesacker" <mgriesac...@gmail.com> wrote:
> > thanks for the safety update, Chris
> > 
> > On Mon, Feb 24, 2014 at 1:28 AM, Chris Egeland 
<ch...@chrisegeland.com>wrote:
> >> Hi everyone,
> >> 
> >> If you come to the space tomorrow, you may notice some half-finished work
> >> on the electrical installation going on in the back half of the space.
> >> 
> >> Andy installed conduit from the breaker panel to the post that has the
> >> hexagonal table.  I installed 2 outlets in the box above, and 4 outlets
> >> in
> >> the box below.  At this time, that circuit is not energized.  The wire is
> >> run into the load center, but is taped off and NOT hooked up to anything.
> >> 
> >>  If you open the electrical panel and notice that there is a spare set of
> >> 
> >> wires coming in, DO NOT HOOK THEM UP YET.
> >> 
> >> Please do not touch the stuff on the electrical panel or the two boxes
> >> that haven't been finished.  I'll complete those tomorrow (Monday) night.
> >> 
> >>  I ran out of steam and couldn't continue any further.
> >> 
> >> Chris
> >> 
> >> _______________________________________________
> >> Discuss mailing list
> >> Discuss@synhak.org
> >> https://synhak.org/mailman/listinfo/discuss
> > 
> > _______________________________________________
> > Discuss mailing list
> > Discuss@synhak.org
> > https://synhak.org/mailman/listinfo/discuss  
_______________________________________________
Discuss mailing list
Discuss@synhak.org
https://synhak.org/mailman/listinfo/discuss

Reply via email to