Hi all,
From the introduction of load-balance-Paths, I think it realizes the fault
tolerance and load balancing of drbd network.
Below is my configuration file??
/etc/drbd.d/drbd1.res??
resource drbd1 {
connection {
path {
host ha-155 address 192.168.122.65:7789;
host ha-156 address 192.168.122.66:7789;
}
path {
host ha-155 address 192.168.122.155:7789;
host ha-156 address 192.168.122.156:7789;
}
}
on ha-155 {
device /dev/drbd1;
disk /dev/sdb;
meta-disk internal;
node-id 1;
}
on ha-156 {
device /dev/drbd1;
disk /dev/sdb;
meta-disk internal;
node-id 2;
}
}
/etc/drbd.d/global_common.conf
net {
load-balance-paths yes;
}
After two network paths are created, run the drbdsetup events2 --now command to
find that the two paths are connected.
After the second network is disconnected, run the drbdsetup events2 --now
command to find that the two paths are still connected.
After the first network is disconnected, run the drbdsetup events2 --now
command to find that both paths are disconnected.
According to my understanding, disconnect one of the networks and keep the
other one connected, but the result is not so.
What's my problem? Do you have any suggestions?
Thanks!
