The DWC2 USB controller in the BCM2835 (Raspberry Pi) needs some non-
default parameters. Select these based on the compatible value from the
DT node. For all other HW, fall back to the default parameters currently
in use.
The values in params_bcm2835[] were posted to the mailing list by Paul
quite some time ago. I made a couple of minor modifications since then;
to set ahbcfg instead of ahb_single, and to set uframe_sched.
Signed-off-by: Stephen Warren <swar...@wwwdotorg.org>
---
Documentation/devicetree/bindings/staging/dwc2.txt | 4 +-
drivers/staging/dwc2/platform.c | 56 ++++++++++++++++----
2 files changed, 50 insertions(+), 10 deletions(-)
diff --git a/Documentation/devicetree/bindings/staging/dwc2.txt
b/Documentation/devicetree/bindings/staging/dwc2.txt
index 1a1b7cf..8b60e90 100644
--- a/Documentation/devicetree/bindings/staging/dwc2.txt
+++ b/Documentation/devicetree/bindings/staging/dwc2.txt
@@ -2,7 +2,9 @@ Platform DesignWare HS OTG USB 2.0 controller
-----------------------------------------------------
Required properties:
-- compatible : "snps,dwc2"
+- compatible : One of:
+ - brcm,bcm2835-usb: The DWC2 USB controller instance in the BCM2835 SoC.
+ - snps,dwc2: A generic DWC2 USB controller with default parameters.
- reg : Should contain 1 register range (address and length)
- interrupts : Should contain 1 interrupt
diff --git a/drivers/staging/dwc2/platform.c b/drivers/staging/dwc2/platform.c
index 4d9fac0..20586dc 100644
--- a/drivers/staging/dwc2/platform.c
+++ b/drivers/staging/dwc2/platform.c
@@ -39,6 +39,7 @@
#include <linux/slab.h>
#include <linux/device.h>
#include <linux/dma-mapping.h>
+#include <linux/of_device.h>
#include <linux/platform_device.h>
#include "core.h"
@@ -46,6 +47,33 @@
static const char dwc2_driver_name[] = "dwc2";
+static const struct dwc2_core_params params_bcm2835 = {
+ .otg_cap = 0, /* HNP/SRP capable */
+ .otg_ver = 0, /* 1.3 */
+ .dma_enable = 1,
+ .dma_desc_enable = 0,
+ .speed = 0, /* High Speed */
+ .enable_dynamic_fifo = 1,
+ .en_multiple_tx_fifo = 1,
+ .host_rx_fifo_size = 774, /* 774 DWORDs */
+ .host_nperio_tx_fifo_size = 256, /* 256 DWORDs */
+ .host_perio_tx_fifo_size = 512, /* 512 DWORDs */
+ .max_transfer_size = 65535,
+ .max_packet_count = 511,
+ .host_channels = 8,
+ .phy_type = 1, /* UTMI */
+ .phy_utmi_width = 8, /* 8 bits */
+ .phy_ulpi_ddr = 0, /* Single */
+ .phy_ulpi_ext_vbus = 0,
+ .i2c_enable = 0,
+ .ulpi_fs_ls = 0,
+ .host_support_fs_ls_low_power = 0,
+ .host_ls_low_power_phy_clk = 0, /* 48 MHz */
+ .ts_dline = 0,
+ .reload_ctl = 0,
+ .ahbcfg = 0x10,
+};
+
/**
* dwc2_driver_remove() - Called when the DWC_otg core is unregistered with the
* DWC_otg driver
@@ -66,6 +94,13 @@ static int dwc2_driver_remove(struct platform_device *dev)
return 0;
}
+static const struct of_device_id dwc2_of_match_table[] = {
+ { .compatible = "brcm,bcm2835-usb", .data = ¶ms_bcm2835 },
+ { .compatible = "snps,dwc2", .data = NULL },
+ {},
+};
+MODULE_DEVICE_TABLE(of, dwc2_of_match_table);
+
/**
* dwc2_driver_probe() - Called when the DWC_otg core is bound to the DWC_otg
* driver
@@ -80,14 +115,23 @@ static int dwc2_driver_remove(struct platform_device *dev)
*/
static int dwc2_driver_probe(struct platform_device *dev)
{
+ const struct of_device_id *match;
+ const struct dwc2_core_params *params;
+ struct dwc2_core_params defparams;
struct dwc2_hsotg *hsotg;
struct resource *res;
int retval;
int irq;
- struct dwc2_core_params params;
+
+ match = of_match_device(dwc2_of_match_table, &dev->dev);
+ if (match)
+ params = match->data;
+ else {
+ dwc2_set_all_params(&defparams, -1);
+ params = &defparams;
+ }
/* Default all params to autodetect */
- dwc2_set_all_params(¶ms, -1);
hsotg = devm_kzalloc(&dev->dev, sizeof(*hsotg), GFP_KERNEL);
if (!hsotg)
@@ -118,7 +162,7 @@ static int dwc2_driver_probe(struct platform_device *dev)
dev_dbg(&dev->dev, "mapped PA %08lx to VA %p\n",
(unsigned long)res->start, hsotg->regs);
- retval = dwc2_hcd_init(hsotg, irq, ¶ms);
+ retval = dwc2_hcd_init(hsotg, irq, params);
if (retval)
return retval;
@@ -127,12 +171,6 @@ static int dwc2_driver_probe(struct platform_device *dev)
return retval;
}
-static const struct of_device_id dwc2_of_match_table[] = {
- { .compatible = "snps,dwc2" },
- {},
-};
-MODULE_DEVICE_TABLE(of, dwc2_of_match_table);
-
static struct platform_driver dwc2_platform_driver = {
.driver = {
.name = dwc2_driver_name,
--
1.7.10.4
_______________________________________________
devel mailing list
de...@linuxdriverproject.org
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
