Blank lines are not needed after opening braces. checkpatch was giving
us warnings about this.
Signed-off-by: Sudip Mukherjee <su...@vectorindia.org>
---
drivers/staging/dgnc/dgnc_cls.c | 4 ----
drivers/staging/dgnc/dgnc_driver.c | 3 ---
drivers/staging/dgnc/dgnc_mgmt.c | 1 -
drivers/staging/dgnc/dgnc_neo.c | 11 -----------
drivers/staging/dgnc/dgnc_tty.c | 11 -----------
5 files changed, 30 deletions(-)
diff --git a/drivers/staging/dgnc/dgnc_cls.c b/drivers/staging/dgnc/dgnc_cls.c
index db997dd..32b05bb 100644
--- a/drivers/staging/dgnc/dgnc_cls.c
+++ b/drivers/staging/dgnc/dgnc_cls.c
@@ -378,7 +378,6 @@ static inline void cls_parse_isr(struct dgnc_board *brd,
uint port)
/* Here we try to figure out what caused the interrupt to happen */
while (1) {
-
isr = readb(&ch->ch_cls_uart->isr_fcr);
/* Bail if no pending interrupt on port */
@@ -472,7 +471,6 @@ static void cls_param(struct tty_struct *tty)
ch->ch_old_baud = 0;
return;
} else if (ch->ch_custom_speed) {
-
baud = ch->ch_custom_speed;
/* Handle transition from B0 */
if (ch->ch_flags & CH_BAUD0) {
@@ -704,7 +702,6 @@ static void cls_tasklet(unsigned long data)
* If board is ready, parse deeper to see if there is anything to do.
*/
if ((state == BOARD_READY) && (ports > 0)) {
-
/* Loop on each port */
for (i = 0; i < ports; i++) {
ch = bd->channels[i];
@@ -999,7 +996,6 @@ static void cls_copy_data_from_queue_to_uart(struct
channel_t *ch)
n = min(n, qlen);
while (n > 0) {
-
/*
* If RTS Toggle mode is on, turn on RTS now if not already set,
* and make sure we get an event when the data transfer has
diff --git a/drivers/staging/dgnc/dgnc_driver.c
b/drivers/staging/dgnc/dgnc_driver.c
index 5cf4837..b47ff6a 100644
--- a/drivers/staging/dgnc/dgnc_driver.c
+++ b/drivers/staging/dgnc/dgnc_driver.c
@@ -418,7 +418,6 @@ static int dgnc_found_board(struct pci_dev *pdev, int id)
brd->irq = pci_irq;
switch (brd->device) {
-
case PCI_DEVICE_CLASSIC_4_DID:
case PCI_DEVICE_CLASSIC_8_DID:
case PCI_DEVICE_CLASSIC_4_422_DID:
@@ -517,7 +516,6 @@ static int dgnc_found_board(struct pci_dev *pdev, int id)
dgnc_do_remap(brd);
if (brd->re_map_membase) {
-
/* Read and store the dvid after remapping */
brd->dvid = readb(brd->re_map_membase + 0x8D);
@@ -610,7 +608,6 @@ static int dgnc_finalize_board_init(struct dgnc_board *brd)
*/
static void dgnc_do_remap(struct dgnc_board *brd)
{
-
if (!brd || brd->magic != DGNC_BOARD_MAGIC)
return;
diff --git a/drivers/staging/dgnc/dgnc_mgmt.c b/drivers/staging/dgnc/dgnc_mgmt.c
index e8aaf35..5f46e69 100644
--- a/drivers/staging/dgnc/dgnc_mgmt.c
+++ b/drivers/staging/dgnc/dgnc_mgmt.c
@@ -99,7 +99,6 @@ long dgnc_mgmt_ioctl(struct file *file, unsigned int cmd,
unsigned long arg)
void __user *uarg = (void __user *) arg;
switch (cmd) {
-
case DIGI_GETDD:
{
/*
diff --git a/drivers/staging/dgnc/dgnc_neo.c b/drivers/staging/dgnc/dgnc_neo.c
index fb95282..3dd7342 100644
--- a/drivers/staging/dgnc/dgnc_neo.c
+++ b/drivers/staging/dgnc/dgnc_neo.c
@@ -320,7 +320,6 @@ static inline void neo_set_no_output_flow_control(struct
channel_t *ch)
/* change UARTs start/stop chars */
static inline void neo_set_new_start_stop_chars(struct channel_t *ch)
{
-
/* if hardware flow control is set, then skip this whole thing */
if (ch->ch_digi.digi_flags & (CTSPACE | RTSPACE) || ch->ch_c_cflag &
CRTSCTS)
return;
@@ -387,7 +386,6 @@ static inline void neo_parse_isr(struct dgnc_board *brd,
uint port)
/* Here we try to figure out what caused the interrupt to happen */
while (1) {
-
isr = readb(&ch->ch_neo_uart->isr_fcr);
/* Bail if no pending interrupt */
@@ -626,7 +624,6 @@ static void neo_param(struct tty_struct *tty)
return;
} else if (ch->ch_custom_speed) {
-
baud = ch->ch_custom_speed;
/* Handle transition from B0 */
if (ch->ch_flags & CH_BAUD0) {
@@ -954,7 +951,6 @@ static irqreturn_t neo_intr(int irq, void *voidbrd)
/* Loop on each port */
while ((uart_poll & 0xff) != 0) {
-
tmp = uart_poll;
/* Check current port to see if it has interrupt pending */
@@ -977,7 +973,6 @@ static irqreturn_t neo_intr(int irq, void *voidbrd)
/* Switch on type of interrupt we have */
switch (type) {
-
case UART_17158_RXRDY_TIMEOUT:
/*
* RXRDY Time-out is cleared by reading data in the
@@ -1141,7 +1136,6 @@ static void neo_copy_data_from_uart_to_queue(struct
channel_t *ch)
total = min(total, qleft);
while (total > 0) {
-
/*
* Grab the linestatus register, we need to check
* to see if there are any errors in the FIFO.
@@ -1206,7 +1200,6 @@ static void neo_copy_data_from_uart_to_queue(struct
channel_t *ch)
* Also deal with any possible queue overflow here as well.
*/
while (1) {
-
/*
* Its possible we have a linestatus from the loop above
* this, so we "OR" on any extra bits.
@@ -1339,7 +1332,6 @@ static void neo_flush_uart_write(struct channel_t *ch)
neo_pci_posting_flush(ch->ch_bd);
for (i = 0; i < 10; i++) {
-
/* Check to see if the UART feels it completely flushed the
FIFO. */
tmp = readb(&ch->ch_neo_uart->isr_fcr);
if (tmp & 4)
@@ -1368,7 +1360,6 @@ static void neo_flush_uart_read(struct channel_t *ch)
neo_pci_posting_flush(ch->ch_bd);
for (i = 0; i < 10; i++) {
-
/* Check to see if the UART feels it completely flushed the
FIFO. */
tmp = readb(&ch->ch_neo_uart->isr_fcr);
if (tmp & 2)
@@ -1473,7 +1464,6 @@ static void neo_copy_data_from_queue_to_uart(struct
channel_t *ch)
n = min(n, qlen);
while (n > 0) {
-
s = ((head >= tail) ? head : WQUEUESIZE) - tail;
s = min(s, n);
@@ -1632,7 +1622,6 @@ static void neo_send_stop_character(struct channel_t *ch)
*/
static void neo_uart_init(struct channel_t *ch)
{
-
writeb(0, &ch->ch_neo_uart->ier);
writeb(0, &ch->ch_neo_uart->efr);
writeb(UART_EFR_ECB, &ch->ch_neo_uart->efr);
diff --git a/drivers/staging/dgnc/dgnc_tty.c b/drivers/staging/dgnc/dgnc_tty.c
index 4a88e1b..9220187 100644
--- a/drivers/staging/dgnc/dgnc_tty.c
+++ b/drivers/staging/dgnc/dgnc_tty.c
@@ -520,7 +520,6 @@ void dgnc_input(struct channel_t *ch)
*/
if (!tp || (tp->magic != TTY_MAGIC) || !(ch->ch_tun.un_flags &
UN_ISOPEN) ||
!(tp->termios.c_cflag & CREAD) || (ch->ch_tun.un_flags &
UN_CLOSING)) {
-
ch->ch_r_head = tail;
/* Force queue flow control to be released, if needed */
@@ -671,7 +670,6 @@ void dgnc_carrier(struct channel_t *ch)
* Test for a VIRTUAL carrier transition to HIGH.
*/
if (((ch->ch_flags & CH_FCAR) == 0) && (virt_carrier == 1)) {
-
/*
* When carrier rises, wake any threads waiting
* for carrier in the open routine.
@@ -685,7 +683,6 @@ void dgnc_carrier(struct channel_t *ch)
* Test for a PHYSICAL carrier transition to HIGH.
*/
if (((ch->ch_flags & CH_CD) == 0) && (phys_carrier == 1)) {
-
/*
* When carrier rises, wake any threads waiting
* for carrier in the open routine.
@@ -706,7 +703,6 @@ void dgnc_carrier(struct channel_t *ch)
*/
if ((virt_carrier == 0) && ((ch->ch_flags & CH_CD) != 0) &&
(phys_carrier == 0)) {
-
/*
* When carrier drops:
*
@@ -1107,7 +1103,6 @@ static int dgnc_tty_open(struct tty_struct *tty, struct
file *file)
* Initialize if neither terminal or printer is open.
*/
if (!((ch->ch_tun.un_flags | ch->ch_pun.un_flags) & UN_ISOPEN)) {
-
/*
* Flush input queues.
*/
@@ -1197,7 +1192,6 @@ static int dgnc_block_til_ready(struct tty_struct *tty,
struct file *file, struc
/* Loop forever */
while (1) {
-
sleep_on_un_flags = 0;
/*
@@ -1222,7 +1216,6 @@ static int dgnc_block_til_ready(struct tty_struct *tty,
struct file *file, struc
* ch_wait_flags to wake us back up.
*/
if (!((ch->ch_tun.un_flags | ch->ch_pun.un_flags) &
UN_CLOSING)) {
-
/*
* Our conditions to leave cleanly and happily:
* 1) NONBLOCKING on the tty is set.
@@ -1390,7 +1383,6 @@ static void dgnc_tty_close(struct tty_struct *tty, struct
file *file)
* DIGI_PRINTER bit is not set.
*/
if ((ch->ch_open_count == 0) && !(ch->ch_digi.digi_flags &
DIGI_PRINTER)) {
-
ch->ch_flags &= ~(CH_STOPI | CH_FORCED_STOPI);
/*
@@ -1419,7 +1411,6 @@ static void dgnc_tty_close(struct tty_struct *tty, struct
file *file)
* If we have HUPCL set, lower DTR and RTS
*/
if (ch->ch_c_cflag & HUPCL) {
-
/* Drop RTS/DTR */
ch->ch_mostat &= ~(UART_MCR_DTR | UART_MCR_RTS);
bd->bd_ops->assert_modem_signals(ch);
@@ -2526,7 +2517,6 @@ static int dgnc_tty_ioctl(struct tty_struct *tty,
unsigned int cmd,
}
switch (cmd) {
-
/* Here are all the standard ioctl's that we MUST implement */
case TCSBRK:
@@ -2735,7 +2725,6 @@ static int dgnc_tty_ioctl(struct tty_struct *tty,
unsigned int cmd,
/* set information for ditty */
if (cmd == (DIGI_SETAW)) {
-
spin_unlock_irqrestore(&ch->ch_lock, flags);
rc = ch->ch_bd->bd_ops->drain(tty, 0);
--
1.9.1
_______________________________________________
devel mailing list
de...@linuxdriverproject.org
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
