the dgnc_offset_table has a same value with (1 << port). So I tried to replace dgnc_offset_table array with 1 << port. And also there are redundant assignments(tmp and current_port) inside while loop for checking uart port, and remove them.
Signed-off-by: Daeseok Youn <daeseok.y...@gmail.com> --- Greg, This patch depends on previous patches. here are links(previous): 1. https://lkml.org/lkml/2016/3/24/661 2. https://lkml.org/lkml/2016/3/24/663 if those patches are failed to merge, I will send them again after fixing them. thanks. drivers/staging/dgnc/dgnc_neo.c | 44 +++++++++++++++++++---------------------- 1 file changed, 20 insertions(+), 24 deletions(-) diff --git a/drivers/staging/dgnc/dgnc_neo.c b/drivers/staging/dgnc/dgnc_neo.c index d732e6e..8b6bc73 100644 --- a/drivers/staging/dgnc/dgnc_neo.c +++ b/drivers/staging/dgnc/dgnc_neo.c @@ -77,9 +77,6 @@ struct board_ops dgnc_neo_ops = { .send_immediate_char = neo_send_immediate_char }; -static uint dgnc_offset_table[8] = { 0x01, 0x02, 0x04, 0x08, - 0x10, 0x20, 0x40, 0x80 }; - /* * This function allows calls to ensure that all outstanding * PCI writes have been completed, by doing a PCI read against @@ -923,9 +920,7 @@ static irqreturn_t neo_intr(int irq, void *voidbrd) struct dgnc_board *brd = voidbrd; struct channel_t *ch; int port = 0; - int type = 0; - int current_port; - u32 tmp; + int type; u32 uart_poll; unsigned long flags; unsigned long flags2; @@ -960,28 +955,29 @@ static irqreturn_t neo_intr(int irq, void *voidbrd) /* At this point, we have at least SOMETHING to service, dig further... */ - current_port = 0; - /* Loop on each port */ while ((uart_poll & 0xff) != 0) { - tmp = uart_poll; - - /* Check current port to see if it has interrupt pending */ - if ((tmp & dgnc_offset_table[current_port]) != 0) { - port = current_port; - type = tmp >> (8 + (port * 3)); - type &= 0x7; - } else { - current_port++; - continue; - } + int i; - /* Remove this port + type from uart_poll */ - uart_poll &= ~(dgnc_offset_table[port]); + type = 0; - if (!type) { - /* If no type, just ignore it, and move onto next port */ - continue; + for (i = port; i < MAXPORTS; i++) { + unsigned int offset_table = 0x1 << i; + + /* Check current port to see + * if it has interrupt pending + */ + if ((uart_poll & offset_table) != 0) { + port = i; + type = uart_poll >> (8 + (port * 3)); + type &= 0x7; + + /* Remove this port + type from uart_poll */ + uart_poll &= ~(offset_table); + } + + if (type) + break; } /* Switch on type of interrupt we have */ -- 1.9.1 _______________________________________________ devel mailing list de...@linuxdriverproject.org http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
