greywing wrote: > . It is my understanding the when power is applied to the receiver, the > button goes red whether it is recognized by the system or not. > .
I reread your post. I pulled a receiver out of storage and plugged it in, red light, then white. I then did a factory reset (hold red until red fast then slow flash), unplugged it, waited 5 minutes, plugged it back in, and it went to the red slow flash. I assume it remembered the "waiting for setup" state. The power supplies are most likely, but, if you wanted to see if the receiver is operational and just the light is bad, you could run through the setup process - - press and hold the receiver button, say 30 seconds (you can't see red flash) - turn off controller (hold power until the exit jingle). Hold "+' on the controller while pressing and holding power until flash or startup jingle. Go through the connect process. Then, on your controller, under choose player, you should see the mac address of the receiver (if it's alive) Jim ------------------------------------------------------------------------ Redrum's Profile: http://forums.slimdevices.com/member.php?userid=33806 View this thread: http://forums.slimdevices.com/showthread.php?t=115629 _______________________________________________ Duet mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/duet
