Hello folks, I intend to construct my own rotator interface. Could be dedicated soft, dedicated Hardware with a some Firmware, say a little ยต controller or even a programable gate array. As I understood, DX4win uses a serial port to put out the data to be used. How is this data structured? How to observe this data and see how I should realize the interface. Unfortunately I dont finf anything on how to input the data into the interface. Who can help ?
----- Original Message ----- From: "W0YG Charlie Summers" <[EMAIL PROTECTED]> To: "DX4WIN" <dx4win@mailman.qth.net> Sent: Friday, June 13, 2003 3:05 PM Subject: [Dx4win] Upgrading from Windows98 to WindowsXP > Folks: > > I just bit the bullet and upgraded my operating system. Now DX4WIN does not > work however I recall seeing a lot of information on this in the past. So, > after searching the archives back for about a year and not finding what I > want, I decided to ask the list. > > When trying to start DX4WIN, I get the message "Port Driver Not Found" and > "Check Appendix: Files for the Correct Driver". Is the solution to > eliminating this message to reinstall DX4WIN and let it put the proper > drivers where they are supposed to be? > > Thanks and 73, > > Charlie, W0YG..>> > > _______________________________________________ > Dx4win mailing list > Dx4win@mailman.qth.net > http://mailman.qth.net/mailman/listinfo/dx4win >
