Credit goes to Bob, W5OV for the following.
Assuming you have MMTTY running stand-alone and correctly PTT keying the
transmitter and sending FSK when your rig is in rtty mode running through
the MicroKEYER. Get that set up first and running properly and then
dont change anything in MMTTY. Then close MMTTY
Then the following Settings:
MicroKEYER
Virtual Port menu, create COM3 COM4 AND COM5
Device menu: load template for DX4WIN
Then set
Control COM3
FSK COM5
CW COM4 DTR
PTT COM5 RTS
then Preset menu
Save as, and name it DX4WIN
A button will appear at the bottom that will allow you to recall the above
settings. You can do the same for MMTTY stand-alone or other programs you
use. If you make any further changes remember to save it again.
Differently numbered COM ports may be used but the numbers used above must
match those below.
In DX4WIN
File, Preferences,
Radio: Set radio type to your radio,
COM port to COM3
Control, CW keying/PTT control
Interface COM4
DTR line CW keying
RTS line PTT control
RTTY tab, RTTY Interface TYPE None
MMTTY at bottom set path to mmtty.exe
Save settings
Open the MMTTY window within DX4WIN then from within MMTTY window hit Alt-S
which will call up a small window named MMTTY keying setup
Set PTT CONTROL and in key line click RTS
(Dont set a COM port in this window)
It should run now..
73, Jay W5SL
----- Original Message -----
From: George Frost
To: [EMAIL PROTECTED]
Sent: 8/25/2005 8:34:09 PM
Subject: RE: [Dx4win] MMTTY IN DX4WIN
Jay what was the solution? KF9WV ....GEORGE
Jay Sewell <[EMAIL PROTECTED]> wrote:
Thanks to all who replied. With the kind help of Bob, W5OV, the problem
was solved. MMTTY works very well FSK with DX4WIN now.
73 Jay W5SL
> [Original Message]
> From: Jay Sewell
> To:
> Date: 8/24/2005 9:47:53 PM
> Subject: [Dx4win] MMTTY IN DX4WIN
>
> I cannot transmit FSK with MMTTY inside DX4WIN. Receives fine. I am
trying to set up FSK through MicroKeyer. All I am able to get is keying of
the rig with a solid tone, no diddle, no transmission of data.
>
> MMTTY works fine stand-alone and works fine with N1MMLogger through the
MicroKeyer, but MicroKeyer refuses to recognize MMTTY for transmission of
data from inside DX4WIN.
>
> Any suggestions?
>
> Thanks and 73,
> Jay W5SL
> _______________________________________________
> Dx4win mailing list
> Dx4win@mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/dx4win
_______________________________________________
Dx4win mailing list
Dx4win@mailman.qth.net
http://mailman.qth.net/mailman/listinfo/dx4win
Jay Sewell
[EMAIL PROTECTED]
