You do have to change ports under preferences... I assume you have done that... the program doesn't ask anything. Older versions ignored port numbers greater than 8. I can think of no reason why the latest version would not work unless the com port is above 32.
Tim wrote: > Mel, > > Thanks for your reply but the computer is recognizing the hardware. > Seems that the program itself doesn't ask for the new port/baud rate > and, therefore, doesn't see the port I'm using. It used to work before > I changed ports but can't get the program to reset the port. I'll keep > working on it. Thanks again. > > Tim > > On Sat, Oct 17, 2009 at 4:40 AM, Mel <ve...@videotron.ca > <mailto:ve...@videotron.ca>> wrote: > > Go to Control Panel and try searching for new hardware. > > Tim wrote: > > It's been awhile since I last used this fine program. Think I > must have > > changed the serial port (using USB adapter) and when I run the > program it > > tells me there is no serial port. I remember that when I first > ran the > > program it allowed me to configure the port and baud rate. Even > after doing > > a new install into a new folder, I get the same message. I > turned off LOGic > > which also interfaces with the K3 so nothing else is connected. > Any ideas > > on how to reset the serial port for this program? Thanks. > > > > Tim K5OI > > > > p.s. Worked K4M on 17M cw and 20M ssb with qrp on the K3. > > _ > > ______________________________________________________________ Dx4win mailing list Home: http://mailman.qth.net/mailman/listinfo/dx4win Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Dx4win@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
