Hi Mike, Data only on RX isn´t suppose to work in DX4WIN But only TX data (kenwood protocol) is available when you setup the steppIR comport. This is because the steppir controller only listen to what is sended to the radio.
Guy ON4AOi > -----Oorspronkelijk bericht----- > Van: dx4win-boun...@mailman.qth.net [mailto:dx4win- > boun...@mailman.qth.net] Namens Mike > Verzonden: maandag 9 augustus 2010 18:09 > CC: dx4win@mailman.qth.net > Onderwerp: Re: [Dx4win] Polling > > On 8/9/2010 10:31 AM, ON4AOI wrote: > > Stop the Radio is the only possibility > > > > > > Guy ON4AOI > Thanks, Guy. > > That would defeat my purpose I believe. The rig has the ability to > broadcast it's > data any time the band or mode changes. I was trying to verify if that > was working or > not. > Of course without knowing if Dx4Win gets data 'onRX' it would still be > an ambiguous test. > > The good news is, it's started to work again. The bad news is I don't > know why. > > 73, Mike > > ______________________________________________________________ > Dx4win mailing list > Home: http://mailman.qth.net/mailman/listinfo/dx4win > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Dx4win@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Dx4win mailing list Home: http://mailman.qth.net/mailman/listinfo/dx4win Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Dx4win@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
