Chuck, Looking on the Internet at the Avery 8387 .. it says that it is 4 cards per sheet and each card is 5.5 X 4.25" ..
Since there is no way to IMPORT a template .. you can go into the label designer and click-on Project / Page Setup and then at the Page Setup TAB, you type in the information about your 8387... I assumed that the 4 cards per sheet are layed out so that the 4.25 is the Horizontal size and the 5.5 is the Vertical Size ... Being an 81/2 X 11" sheet .. I put in 4.25 in the SIZE Horizontal and 5.5 in the SIZE Vertical.. Then, put in 2 for the NUMBER Horizontal and 2 for the NUMBER Vertical.. I assumed that the OFFSET and DISTANCE categories are 0.00 ... again, I am assuming a lot on this setup - since I have never seen the 8387.. If you need further info - feel free to send me an email.. 73 de Joe wa6axe Chuck K0XM wrote: > > Ok, here's one for ya... > I am trying to add an Avery 8387 card template to the definitions. I have > the template from Avery, in Word format. How do I get the import to accept > it and allow me to save it using the list designer. Either I can 't figure > it or, it is WAY too early in the morning and I need to really go work some > dx and worry about it later... > Chuck/K0XM > > _______________________________________________ > DXBase Reflector - Please visit us on the web at www.dxbase.com > - - - - - - - - - - - - - - - - - - - - - - - > To UNSUBSCRIBE please visit: > http://mailman.qth.net/mailman/listinfo/dxbase
