Below is a workaround to the CW problem some people have with DXB 2004:
I had several people inquire about a solution to the DXBase 2004 inability to send CW on my LPT port. I was able to devise a workaround. I went into the DXBASE.INI file and changed the line that reads DXBPORT=Dxb24 LPT1 to DXBPORT=Dxb98 LPT1 My CW now works with DXBase 2004. I know its not the best solution, but at least it works! -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Michael L. Therrien, MD Sent: Tuesday, July 08, 2003 7:04 AM To: [email protected] Subject: [DXBase] Lost CW functionality in Dxbase 2004 Set up Dxbase 2004 last night. Had Dxbase 2002 running fine. Same machine, same ports. I cannot get CW from LPT 1. COM ports seem to act OK, though the rotor on COM 3 has a problem not seen in Dxbase 2002. Commanding the rotor to move creates a situation where the whole machine freezes for 60-90 sec then the rotor moves to the correct position and the program resumes. I have used the driver update program and verified the ports in Control Panel. Any ideas what I should do next? BTW I still have Dxbase 2002 in a separate directory from 2004. Is this OK? Might it create conflicts of some type? Tnx Mike, N1MD Michael L. Therrien, MD, MMM, CPE Amateur Radio Station N1MD "Primum non nocere" _______________________________________________ DXBase Reflector - Please visit us on the web at www.dxbase.com - - - - - - - - - - - - - - - - - - - - - - - To UNSUBSCRIBE please visit: http://mailman.qth.net/mailman/listinfo/dxbase
