I'd like some help to set the user options for DX base to work with FT 100d . I have the CAT cable ..and the freq readout is erroneous . Thanks !! Peter W0SA / 8P9NX [EMAIL PROTECTED]
************************************** See what's free at http://www.aol.com. From [EMAIL PROTECTED] Thu May 31 20:02:06 2007 From: [EMAIL PROTECTED] (FireBrick) Date: Thu May 31 20:05:02 2007 Subject: [Dxbase] FT 100 D settings References: <[EMAIL PROTECTED]> Message-ID: <[EMAIL PROTECTED]> Pete I'm not familiar with the ft100d. but right off the bat, most Yaesu products demand 2 stop bits. Check that in the port setup. So in Radio one (I'm assuming). You would have the Yaesu fT100d selected and the appropriate com port. 4800 baud, word length 8, None Parity and Stop Bits 2. these are pretty common parameters for Yaesu FT series. Make sure you have no other conflict with that com port. Good luck, wish I knew more about the 100D ----- Original Message ----- From: <[EMAIL PROTECTED]> To: <[email protected]> Sent: Thursday, May 31, 2007 6:51 PM Subject: [Dxbase] FT 100 D settings > I'd like some help to set the user options for DX base to work with FT > 100d > . I have the CAT cable ..and the freq readout is erroneous . Thanks !! > > Peter W0SA / 8P9NX [EMAIL PROTECTED] > > > > ************************************** See what's free at > http://www.aol.com. > ______________________________________________________________ > Dxbase mailing list > Home: http://mailman.qth.net/mailman/listinfo/dxbase > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] >
