Gert, When you open the label/card file -- be sure that you are specifying the correct number of DATA lines that are on the label/card --
When the small window (entitled: Select Label Type) opens, be sure that you fill-in the "QSOs Per Label" with the correct info. If the file has THREE lines of data (max that it can handle) - then type in "QSOs Per Label" = 3 73 Joe WA6AXE > From: [email protected] > To: [email protected] > Date: Fri, 16 Nov 2012 14:50:06 +0000 > Subject: [Dxbase] Label Designer in DXBase2007 v1.10 > > I recently switched from DXBase2007 to DXbase2007 v1.10 > In DXbase v1.10 the Label Designer is different from the one in DXbase 2007. > The new label design program does not recognise a design made with the old > label designer regarding printing multiple QSO 's on one QSL card. > It "accepts" the first QSO line but not the following lines. > The error message generated says: Syntax error: cannot interpret term MODE2, > it says this for all the folowing fields from the oher QSO lines. > Anyone else noticed this ? > Any solutions? > > Thanks, > > Gert, PA3AAV > ______________________________________________________________ > Dxbase mailing list > Home: http://mailman.qth.net/mailman/listinfo/dxbase > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
