Let's TRY this again...
Halvard, I am the author of the MixWBridge and if you have a Windows7 64 bit O/S and if you have DXbase2007 ver 1.10 installed right off of C:\ drive -- (1) Make sure that YOU have SETUP your new install OPTIONS / General TAB .. DXBPsk Interface area -- Checkmark AUTO SAVE QSO (2) The one thing that I just ran into on my Win7 64bit laptop - was that I MUST go into the MixWBridge.exe program file Properties -- and under the Compatability TAB In the Compatability mode area -- ""CHECKMARK"" the following and select for: Run this program in Compatability mode for: Windows XP (Service Pack 3) THEN CHECKMARK also Run this program as an adminstrator NOW -- press apply -- then press ok.. This should make it work --- the above steps just now HELPED ME get MixW to log directly to DXbase2007 ver 1.10 using MY MixWBridge ... GL!! Joe wa6axe On 05/14/14, Halvard Eriksen<[email protected]> wrote: I just updated my DxBase2007 from ver.1.06 to 1.10 an MixW Bridge does not work any more. When I save a QSO in MixW it is no longer saved in DxBase. This worked fine with DxBase v1.06 My MixW is ver. 3.01 and has not been changed. Does anyone have a solution? 73 de Halvard, LA7XK ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
