I have been using the same version of DXBase for several years. It is DXBase 2007 Version 1.06 and it is on a Windows XP machine. It works great and I have seen no reason to change it. The other day, on a lark, I thought I would set up the CW memories so that I could send from DXBase. I have used Writelog for years and it sends CW very nicely using my Microham CW Keyer.
I set it up and it seemed to work fine, seemed like it was a little flakey but nothing I could put my finger on. After a week or so I got an "out of memory" message from the computer. I leave DXBase running all the time and reboot seldom so I figured it needed to be rebooted. I did that and it worked OK but after a week or so I got the "out of memory" message again and this time it locked up the computer. I looked to see what I had running in the background and found nothing unusual. I am certainly not very knowledgeable about computers. I went in and reset the comport that I was using so that the CW memories wouldn't work and have had no further problems. This is not a big deal, I would seldom use the CW memories but I am a little curious if anyone else has run into this? W5VX, Bill Parry ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
