Thank you Joe for your amazingly quick answer.
Wes
On 7/15/2018 11:49 AM, Joseph Glockner wrote:
Wes,
Looking at the ICOM 7600 commands, etc -- the only thing that I think you
would have to change is the ADDRESS
Yours would become
Address=0x98
This as per the 7610 CAT Commands pdf file ..
http://www.icom.co.jp/world/support/download/manual/pdf/IC-7610_ENG_CI-V_0a.pdf
Joseph Glockner
[email protected]
-----Original Message-----
From: Wes N7WS <[email protected]>
To: 'DXBase Reflector' <[email protected]>
Sent: Sun, Jul 15, 2018 1:36 pm
Subject: [Dxbase] Icom connections
After using Elecraft radios for ten years and Kenwood before that (Elecraft
copied the Kenwood protocol) reliability issues have me considering a new
radio. an Icom 7610. Has anyone interfaced one of these to DXBase. I don't
see it in the list of Icom radios, but imagine it's similar to others which
are. I'm trying to anticipate the interfacing issues that I might have. Wes
N7WS ______________________________________________________________ Dxbase
mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help:
http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
<mailto:[email protected]?> This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Dxbase mailing list
Home: http://mailman.qth.net/mailman/listinfo/dxbase
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
