J'ai fais un eaglediag -scdm et voilà le log si ça dit
quelque chose à quelqu'un Very Happy :
Diagnostic (1.18 2004/11/04) driver eagle-usb
20041225160605
# System Information
Linux lapbox 2.6.1 #13 SMP Sun May 16 09:10:01 CEST
2004 i686 GNU/Linux
3.1
Linux version 2.6.1 ([EMAIL PROTECTED]) (gcc version 3.3.3
(Debian 20040429)) #13 SMP Sun May 16 09:10:01 CEST
2004
gcc version 3.3.5 (Debian 1:3.3.5-4)
# Dependances
ppp 2.4.2+20040428-5 install ok installed
dhcp-client unknown ok not-installed
dhcpcd purge ok not-installed
drwxrwxr-x 19 1046 1046 1216 Sep 30 17:29 linux-2.6.1
-rw-r--r-- 1 root joe 33240033 Jan 9 2004
linux-2.6.1.tar.bz2
Warning : available gcc and the version used to
compile the kernel differ
Advice : that's a standard problem on debian, revert
to gcc version used for kernel
# Kernel config : usb modules
ppp_async 12288 0
ppp_generic 32528 1 ppp_async
slhc 7936 1 ppp_generic
eagle_usb 125888 0
ohci1394 34948 0
# disk uses dma ? [ OK ]
# module loaded ? [ OK ]
# modem operational ? [ OK ]
eagle-usb status display
-------------------------------------------------------------
Driver version 2 Chipset: Eagle2
Vendor ID : 0x1110 Product ID : 0x9021 Rev: 0x500b
USB Bus : 002 USB Device : 003 Dbg mask: 0x0
Ethernet Interface : eth1
MAC: 00:30:0a:1e:b6:ac
Tx Rate 416 Rx Rate 4160
FEC 0 Margin 26 Atten 21 dB
VID-CPE 0 VID-CO 28 HEC 0
VPI 0 VCI 50 Delin GOOD
Cells Tx 41 Cells Rx 44
Pkts Tx 33 Pkts Rx 39
OAM 0 Bad VPI 0 Bad CRC 0
Oversiz. 0
Modem is operational
# Config vpi/vci/encapsulation/isp : 32 5 (pppoa) CH02
# pppd launched ? [ KO ]
# /etc/resolv.conf should contain the DNS
213.42.20.20
195.229.241.222
#nameserver 192.168.0.254
eth0 Link encap:Ethernet HWaddr 08:00:46:BE:28:EA
inet addr:192.168.0.3 Bcast:192.168.0.255
Mask:255.255.255.0
inet6 addr: fe80::a00:46ff:febe:28ea/64 Scope:Link
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:2519 errors:0 dropped:0 overruns:0
carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:159911 (156.1 KiB)
Interrupt:11 Base address:0x7c00
eth1 Link encap:Ethernet HWaddr 00:30:0A:1E:B6:AC
inet6 addr: fe80::230:aff:fe1e:b6ac/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:65531 Metric:1
RX packets:39 errors:0 dropped:0 overruns:0 frame:0
TX packets:33 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:746 (746.0 b) TX bytes:1410 (1.3 KiB)
ipddp0 Link encap:UNSPEC HWaddr
00-00-00-00-00-00-30-3A-00-00-00-00-00-00-00-00
BROADCAST NOARP MULTICAST MTU:585 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:918 errors:0 dropped:0 overruns:0 frame:0
TX packets:918 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:53996 (52.7 KiB) TX bytes:53996 (52.7 KiB)
sit0 Link encap:IPv6-in-IPv4
NOARP MTU:1480 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.0.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
# ping IP ? [ KO ]
# test DNS resolution ? [ KO ]
comme vous pouvez le voir mon pppd ne veut pas
démarrer pourtant j'ai bien rentrer les DNS indiqués
dans /etc/resolv.conf
merci d'avance
Pat
PS:quand je fais modprobe -r eagle-usb ça me fait un
kernel panic et rebootage obligatoire, même chose
quand je débranche le modem direct.
__________________________________
Do you Yahoo!?
Yahoo! Mail - Easier than ever with enhanced search. Learn more.
http://info.mail.yahoo.com/mail_250
