Hi All, I wanted to write a sample application using sockets. I have built eCos image with redboot enabled. I was able to boot the target PC using redboot, do ping to the target and telent also.
I wanted to test a socket application. For this have used the following procedure: 1. Created a new project. In "build" templates, "hardware" i have selected i386 PC target and "packages" i have selected "net". 2.In the basic networking options initializing options for eth0 i have set the static ip address for the target. 3.I have build the library. 4.In $(CUR_WORKING)/ecos-2.0/packages/net/common/ver_2.0/common/tests i compiled nc6_test_slave program 5.I tried to run it using configtool. In the "tools" menu i have selected "run tests". I have added the exe using add option tried to run it the target system which was booted using reboot. After series of lines It displays Final load[16] = 203142 => 19% Start test for eth0 Family: 2, Socket: 2, Addr: 0.0.0.0 It stops here.. But according to the doc in the net/ver_2.0/common/doc/ it should be Start test for eth0 Family: 2, Socket: 2, Addr: 0.0.0.0 Family: 28, Socket: 2, Addr: :: Then it says to run the master apllication on host (Linux in my case). I have compiled on Linux. Do I need to enable any option in the configuration . I don't know where exactly i am doing a mistake. Is there any document which says how to write and test a sample application using sockets. Can anybody help me out with this. Regards, Madhava S
This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely for the use of the addressee(s). If you are not the intended recipient, please notify the sender by e-mail and delete the original message.Global Edge Software Ltd has taken every reasonable precaution to minimize this risk, but is not liable for any damage you may sustain as a result of any virus in this e-mail. You should carry out your own virus checks before opening the e-mail or attachment. Global Edge Software Ltd reserves the right to monitor and review the content of all messages sent to or from this e-mail address
-- Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss
