On Tue, 09 Sep 2008 15:48:48 +0200, Andrew Lunn <[EMAIL PROTECTED]> wrote:
On Tue, Sep 09, 2008 at 03:30:44PM +0200, Robert Brusa wrote:
Hi
I am "booting" a AT91SAM7X-based board. Previously, with the eval-board,
diag_printf went to the debug serial interface. The new board does not
use this interface, instead I would like to assign UART1 to diag_printf.
I digged into the documentation, but could find now solution to my
problem. Thanks for an advice.
Take a look at CYGNUM_HAL_VIRTUAL_VECTOR_CONSOLE_CHANNEL. You probably
need to set the value to 1.
Andrew
Yes, that did it! Thank you and nice evening.
Robert
--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss
