If the requirement for PCI to display the information when there are no parameters present, I see no reason that it could not also use a file for input. i.e. "pci" must act according to the spec, but "pci < inputfile" is not prohibited. I think that as no code currently uses PCI with file input as long as current behavior still works it should be fine.
I would think that would be a great improvement for the PCI command. -Jaben > -----Original Message----- > From: edk2-devel [mailto:edk2-devel-boun...@lists.01.org] On Behalf Of > jim.dai...@dell.com > Sent: Thursday, September 21, 2017 4:52 AM > To: tiger...@zhaoxin.com > Cc: edk2-devel@lists.01.org > Subject: Re: [edk2] Shell input redirection question > Importance: High > > The shell's pci command was not written to read from standard input. It > expects all its input on the command line. > > I would say in general that if you execute a command and pass it no > parameters, and it then prompts you in some way for input, then that > command will likely accept input redirected from a file. > > If you execute pci without any parameters, it simply lists all the > devices in the system and terminates, so it clearly is not prepared to > read from standard input (or a redirected file). > > It is strictly up to whomever writes a program/command whether they do > so in a manner that allows it to accept input from standard input. For > example, I have written a grep utility for the shell that expects one or > more filenames to search to be on the command line; however, if there > are no filenames on the command line, the utility searches standard > input. > > Regards, > Jim > > -----Original Message----- > From: edk2-devel [mailto:edk2-devel-boun...@lists.01.org] On Behalf Of > Tiger Liu > Sent: Thursday, September 21, 2017 1:11 AM > To: edk2-devel@lists.01.org > Subject: [edk2] Shell input redirection question > > Hi, experts: > I have a question about input redirection in Shell environment. > > Take pci command as sample. > I wrote a txt file(file name is : inputsample.txt), its content is: > 00 00 01 -i > 00 00 02 –i > > It means I just wanted to dump D0F1/D0F2’s config space. > > Then, I use this command sequence in shell : > pci <a inputsample.txt > > But it seems not recognize this input file’s content. > > Why? > > Thanks > > best wishes, > > > 保密声明: > 本邮件含有保密或专有信息,仅供指定收件人使用。严禁对本邮件 > 或其内容做任何未经授权的查阅、使用、复制或转发。 > CONFIDENTIAL NOTE: > This email contains confidential or legally privileged information and is for > the > sole use of its intended recipient. Any unauthorized review, use, copying or > forwarding of this email or the content of this email is strictly prohibited. > _______________________________________________ > edk2-devel mailing list > edk2-devel@lists.01.org > https://lists.01.org/mailman/listinfo/edk2-devel > _______________________________________________ > edk2-devel mailing list > edk2-devel@lists.01.org > https://lists.01.org/mailman/listinfo/edk2-devel _______________________________________________ edk2-devel mailing list edk2-devel@lists.01.org https://lists.01.org/mailman/listinfo/edk2-devel