I think this can be changed in secondary menu. ----- Original Message ----- From: <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]>; <Elecraft@mailman.qth.net> Sent: Monday, July 05, 2004 6:11 PM Subject: Re: [Elecraft] Tuning Rates and fine tune shift.
> Dave, > > I can get my recent K2 built and calibrated about two months back to give > the same change of the last digit on the full display (10Hz steps) when changing > tuning steps (RATE). I had seen this pop up on odd occasions when going > from different tuning rates, but could not pin down the mechanics of it. > > Now seem to be able to duplicate the effect on a regular basis with the > following steps: > > 1. Set the display on 10Hz steps and zero the last digit of the display. > 2. TAP the RATE button once to remove the last two display digits and the > tuning rate to 1kHz steps. > 3. Turn the VFO at this 1kHz rate to another setting. > 4. TAP the RATE button once to add the first of the last two digits on > the display and the tuning rate to 100Hz steps. > 5. Turn the VFO at this 100Hz rate to another setting. > 6. TAP the RATE button once to add the last digit of the display and the > tuning rate to 10Hz steps. Find the last digit now reads 5 even though it was > left on zero. > > There may be other ways of duplicating the effect though not stumbled on to > those as yet. Seem to remember there was a discussion on what could be a > similar topic about a month or two back in regard to exactly setting of the BFO > or some other preset frequencies during calibration and it was said to be > related to the resolution of the ADC in the K2. > > > Bob, G3VVT > K2 #4168 > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com