Hello All, I've had a problem crop up that has me scratching my head. I have K2 #3311 with the KPA100 and the KAT100. It's possible this problem has existed for a while, but I've just noticed it when trying to rebuild my antennas after a microburst attack. I can set the power level, according to the front panel from .1 Watt to 110 Watts, the relay clicks in at 10 Watts and the indicator on the ATU shows the change from high to low. Unfortunately, the low level is about 20 Watts only on a power meter, and high power is only 110 watts, no adjustment. I'm not getting a Hi Current message as well. Any suggestions where to look? I've checked for burnt components, open R50, I don't appear to be getting any KPA100 bias voltage. The Cal Cur is set at 2.00 (did try adjusting it to 3.50 Amps, per the KPA manual). It had been operating correctly, but have only operated sporadically for the past few months.
Thanks in advance, Julius n2wn _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com