Does it help to lower level of spot tone? I use spot often on my K2 3829 and no distortion heard , but I have never run it on high levels? I adjust level on spot so an incoming signal blanks it out when pitch is near optimal center. Tom LA1PHA How is your transmitted signal? Any stray from PS?
----- Original Message ----- From: "Jay Blass" <[EMAIL PROTECTED]> To: <Elecraft@mailman.qth.net> Sent: Wednesday, August 04, 2004 9:59 PM Subject: [Elecraft] K2 Spot causes signal distortion Just getting K2 4329 aligned and on the air. All alignments are complete (thanks to spectrogram and Tom Hammond), but I have found that activating the spot tone feature distorts the incoming rx signal. This is very evident both auditory and when viewing the signal on Spectrogram. I've used Spotting on the K1 extensively, but the current situation on the K2 makes this feature unusable. Any ideas? Jay N5ACM _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
