Simply remove your kxat1, re-jumper pins 1 and 3 of j7 near the antenna jack, and follow the Receiver Alignment procedure outlined on p45 of your kx1 manual. Then when this is doen, re-install your kxat1.
kb3ipe dt . --- Tony Morgan <[EMAIL PROTECTED]> wrote: > Hi Guys, > Have almost completed KX1 #770. > Everything is fine so far. My question is with the KXAT1 installed, how do I > get to trimmer 20A on the KX1 board? > In the KXB30 manual, page 7, last step it says to re-align rcvr on 20 mtrs. > > Thanks, > > Tony W7GO > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com